Robotic vacuum keeps climbing the wall and flipping over

Got a new robotic cleaner and instead of scrubbing the floor, half the time it climbs straight up the wall and then tips on its side. Looks like a turtle stuck upside down. Anyone else dealt with this?
 
Mine used to do that too, climbing up the wall and flipping over. Try changing the wheels or check the pump, that’s often the issue.
 
I’ve had this too usually weak grip and circulation pushing it. Try new tracks/brushes, run it with the pump off, and check the buoyancy foam/wheels are snug. After that mine stopped climbing walls and flipping
 
I’ve had the same issue before. It’s usually the grip or brushes getting weak, so I replaced them and the problem went away.
 
I have seen this with new robots when buoyancy or traction is slightly off, especially if the walls are slick, so I check that the filter basket is seated right and clean the waterline so it does not climb too aggressively, and after I cleaned the walls with aquadoc tile and vinyl cleaner mine stopped tipping over and stayed focused on the floor.
 
Last edited:
I laughed at the turtle comment because I’ve been there.

If it’s a brand new unit, one thing people don’t think about is weight balance from the filter basket. On my Dolphin Nautilus CC Supreme, when the basket is completely clean and dry, it’s actually lighter and climbs more aggressively. Once there’s a little debris weight in it, it behaves differently and doesn’t try to summit Everest every cycle.

Also check your water chemistry from a balance standpoint, not just sanitizer. When my pH drifted up near 7.9 and my calcium hardness was high, the walls felt slicker. The robot would rocket up, lose traction near the waterline, and tip sideways on the way down. When I brought pH back to around 7.5 and kept my saturation index slightly negative instead of scaling, it gripped more predictably.

Another simple test is to run it with the main pump off like someone mentioned. Strong return flow can push it sideways as it climbs, especially if your filter pressure is 5 to 8 psi over clean and flow patterns are uneven.

If it flips in the exact same spot each time, that’s usually circulation or a slightly unbalanced unit. If it’s random, I’d look at tracks, foam, or even how the cable is floating. Does it climb all the way to the tile line before tipping, or is it losing balance halfway up?
 
That turtle description is pretty accurate. I had a robot that did the same stunt for a while and it wasn’t broken, it was just a little too eager to climb.

One thing I noticed was the cable and balance affecting it more than I expected. If the floating cable bunches up or pulls slightly to one side, the cleaner can climb straight up and then lose balance when it tries to rotate back down. When that happens it tips and sits there spinning like it’s confused. I started stretching the cable out across the pool for a minute before dropping the robot in and it stopped happening nearly as much.

Another thing to look at is how slick the walls are. When my pH drifted up close to 7.8 and the calcium hardness was on the higher side, the tile line and walls got a little slippery from early scale forming. The robot would rocket up the wall, lose traction right near the waterline, then flip sideways on the way down. Once I brushed the walls and got the balance back closer to the mid 7s, it gripped a lot better and stayed on the floor more.

Also try running it when the main pump is off if you haven’t already. Strong return flow can push a climbing robot sideways which is just enough to make it roll over. Does it flip in the same area every time or kind of randomly around the pool? That usually tells you if it’s circulation or just balance.
 
Back
Top